Suzuki Wagon R Manual page 3768

C-13: Camshaft Position Sensor Circuit
Test Table
Test
T01 Check: Interruption of Voltage Supply Circuit
• Ignition OFF
• Disconnect wiring harness connector from:
CMP sensor
• Ignition ON
• Measure voltage between the following terminals:
CMP sensor - Wiring harness connector (wiring harness side) ter-
minal C26-3
&
Ground
Yes: T02
T02 Check: Short to Voltage/Interruption of Ground Circuit
• Measure voltage between the following terminals:
CMP sensor - Wiring harness connector (wiring harness side) ter-
minal C26-3
&
CMP sensor - Wiring harness connector (wiring harness side) ter-
minal C26-1
Yes: T03
T03 Check: Short to Voltage/Ground/Interruption of Signal Circuit
• Measure voltage between the following terminals:
CMP sensor - Wiring harness connector (wiring harness side) ter-
minal C26-2
&
Ground
Yes: T04
T04 Check: Mechanical Functionality
• Check the following system for proper operation:
CMP sensor
(intermittent problems, missing teeth, wrong reference point, incor-
rect gap position, etc.)
Yes: E01
T05 Check: Short to Voltage/Ground/Interruption of Signal Circuit
• Measure voltage between the following terminals:
CMP sensor - Wiring harness connector (wiring harness side) ter-
minal C26-2
&
Ground
Yes: E03
ENGINE GENERAL INFORMATION AND DIAGNOSIS (Z10XEP AND Z12XEP ENGINES) 6-4-87
Work Order Description Nominal Value
4.8 – 5.2 V
No: E06
4.8 – 5.2 V
No: E05
4.8 – 5.2 V
No: T05
Test OK?
No: E02
greater than 5.2 V
No: E04