Suzuki Wagon R Manual page 3174

2
1
3
2
1
4
3
Water Pump/Generator Drive Belt Removal
and Installation
Removal
1) Disconnect negative cable at battery.
2) If vehicle equipped with A/C, remove compressor drive belt
(4) before removing water pump belt (1).
Refer to "Compressor Drive Belt Removal and Installation" in
Section 1B.
3) Loosen drive belt adjusting bolt (2) and generator pivot bolt
4
(3).
4) Slacken belt by displacing generator and then remove it.
Installation
1) Install belt (1) to water pump pulley (2), crankshaft pulley (3)
and generator pulley (4).
2) Adjust belt tension by referring to "Water Pump/Generator
Drive Belt Tension Inspection and Adjustment" in this sec-
tion.
5
3) If vehicle equipped with A/C, install compressor drive belt (5)
referring to "Compressor Drive Belt Removal and Installa-
tion" in Section 1B.
4) Connect negative cable at battery.
ENGINE COOLING (M13 ENGINE) 6B2-15