Suzuki Wagon R Manual page 3195

6E2-18 ENGINE AND EMISSION CONTROL SYSTEM (M13 ENGINE)
4
5
1
5) Disconnect connectors from TP sensor (1) and IAC valve (2).
1
6) Disconnect engine coolant hoses (3) and breather hose (4)
3
7) Remove throttle body from intake manifold.
2
8) Remove TP sensor and IAC valve from throttle body.
NOTE:
While disassembling and assembling throttle body, use
special care not to deform levers on throttle valve shaft
or cause damage to any other parts.
Installation
1) Install IAC valve to throttle body referring to "Installation"
2) Install TP sensor to throttle body referring to "Installation"
3) Clean mating surfaces and install new throttle body gasket
1
4) Install throttle body (1) to intake manifold.
5) Connect connectors to TP sensor (2) and IAC valve (3)
2
4
6) Connect engine coolant hoses (4) and breather hose (5).
7) Connect accelerator cable and adjust cable play to specifica-
8) Install air cleaner outlet hose and purge valve chamber.
3
9) Refill coolant referring to "Cooling System Refill" in Section
10) Connect negative cable at battery.
from throttle body.
under "IAC Valve Removal and Installation" in this section.
under "TP Sensor Removal and Installation" in this section.
(1) to intake manifold.
securely.
tion.
6B2.