Suzuki Wagon R Manual page 3669

4A5-10 FRONT DRIVE SHAFT (Z12XEP ENGINE MODEL)
(A)
8) Place new wheel side boot small band (1) onto boot putting
band outer end (2) against forward rotation (3) as shown in
figure.
9) Confirm that wheel side boot is not stretched or contracted,
and then fasten boot small band (1) securely using special
tool.
Special tool
(A): 09943-55010 or 09943-57010
1
10) Install damper (1) on right side drive shaft according to
dimension specified below.
Length "a": 347 – 353 mm (13.66 – 13.89 in.)
11) Set new differential side boot small band and differential side
boot (1) on shaft temporarily.
12) Install tripod joint (2) on shaft by using special tool with ham-
mer, facing its chamfered spline inward (wheel side), then
fasten it with snap ring (3).
Special tool
(A): 09900-06107
(B): 09925-98221
13) Apply grease to tripod joint and inside of housing then install
housing. Use grease supplied with spare parts.
Grease color: dark brown
Amount: Approximately 120 g (4.23 oz)