Suzuki Wagon R Manual page 4065

8G4-10 IMMOBILIZER CONTROL SYSTEM (Z10XEP / Z12XEP ENGINE MODELS)
Scan Tool Data
As the data value given below are standard values estimated on the basis of values obtained from the normally
operating vehicles by using a scan tool, use them as reference values. Even when the vehicle is in good condi-
tion, there may be cases where the checked value does not fall within each specified data range. Therefore,
judgment as abnormal should not be made by checking with these data alone.
Also, conditions in the table below that can be checked by the scan tool are those detected by immobilizer con-
trol module and output from immobilizer control module as commands.
Scan Tool Data
IGNITION SWITCH
PASSWORD
TRANSPONDER
FIX CODE (IGN KEY)
NUMBER OF FIX CODE
TRANS SECRET KEY
WAIT LOOP
WAIT TIME
Scan Tool Data Definitions
IGNITION SW
Ignition key switch position
ON: Ignition switch at ON position
OFF: Ignition switch at OFF position
PASSWORD
REGISTERED: Password is registered in immobilizer control module.
NOT REGISTERED: Password is not registered. It is necessary to register password to set immobilizer control
module in normal operation status.
TRANSPONDER
DETECTED: Transponder in ignition key is detected by immobilizer control module.
NOT REGISTERED: Transponder in ignition key is not detected.
FIX CODE
REGISTERED: The FIX CODE of ignition key which is inserted in key cylinder is registered in immobilizer con-
trol module.
NOT REGISTERED: The FIX CODE of ignition key which is inserted in key cylinder is not registered in immobi-
lizer control module.
NUMBER OF FIX CODE (PCS)
The number of registered ignition key (FIX CODE).
TRANS SECRET KEY
REGISTERED: Secret key is registered in ignition key with built-in transponder.
NOT REGISTERED: Secret key is not registered in ignition key with built-in transponder yet.
WAIT-LOOP
INACTIVE: Security system is inactive. It is ready for password input on scan tool.
ACTIVE: Incorrect password was inputted and system is in wait-loop status. Inputting password is inhibited for
the waiting time described below.
Vehicle Condition
Ignition switch turned to ON position
(Vehicle is in normal condition)
Ignition switch turned to ON position
Ignition switch turned to ON position
(Vehicle is in normal condition)
Ignition switch turned to ON position
(Vehicle is in normal condition)
(Vehicle is in normal condition)
Normal Condition /
Reference Values
ON
PROGRAMMED
DETECTED
REGISTERED
1 – 5 pcs
REGISTERED
INACTIVE
0 SEC