Suzuki Wagon R Manual page 4022

WARNING:
For vehicles equipped with a Supplemental Restraint (Air Bag) System:
• Service on and around the air bag system components or wiring must be performed only by an
authorized SUZUKI dealer. Refer to "Air Bag System Components and Wiring Location View" under
"General Description" in air bag system section in order to confirm whether you are performing ser-
vice on or near the air bag system components or wiring. Please observe all WARNINGS and "Ser-
vice Precautions" under "On-Vehicle Service" in air bag system section before performing service
on or around the air bag system components or wiring. Failure to follow WARNINGS could result in
unintentional activation of the system or could render the system inoperative. Either of these two
conditions may result in severe injury.
• Technical service work must be started at least 90 seconds after the ignition switch is turned to the
"LOCK" position and the negative cable is disconnected from the battery. Otherwise, the system
may be activated by reserve energy in the Sensing and Diagnostic Module (SDM).
General Description ..................................... 7C5-2
Diagnosis ...................................................... 7C5-2
Diagnosis Table ......................................... 7C5-2
On-Vehicle Service....................................... 7C5-3
Clutch Cable Components ......................... 7C5-3
Clutch Cable Removal and Installation ...... 7C5-4
Clutch Cable Inspection ............................. 7C5-5
Clutch Pedal Inspection ............................. 7C5-6
Clutch pedal free travel .......................... 7C5-6
Clutch Pedal with Bracket Removal and
Installation .................................................. 7C5-6
Unit Repair Overhaul ................................... 7C5-8
SECTION 7C5
CLUTCH
(Z12XEP ENGINE MODEL)
CONTENTS
CLUTCH (Z12XEP ENGINE MODEL) 7C5-1
Clutch Cover and Clutch Disc and
Flywheel Components ............................... 7C5-8
Clutch Cover and Clutch Disc and
Flywheel Removal and Installation ............ 7C5-9
Clutch Cover and Clutch Disc and
Flywheel Inspection ................................. 7C5-10
Clutch Release Mechanism Removal
and Installation......................................... 7C5-11
Clutch Release Mechanism Inspection .... 7C5-12
Tightening Torque Specification .............. 7C5-13
Required Service Material ......................... 7C5-13
Special Tool................................................ 7C5-13
7C5