Suzuki Wagon R Manual page 3886

1
ENGINE MECHANICAL (Z10XEP AND Z12XEP ENGINES) 6A4-59
Removal
1) Remove engine assembly from engine compartment refer-
ring to "Engine Assembly Removal and Installation" in this
section.
2) Remove cylinder head referring to "Valves and Cylinder
Head Removal and Installation" in this section.
3) Mark cylinder number on all pistons, connecting rods, con-
necting rod caps and connecting rod bearings using silver
pencil or quick drying paint.
4) Remove special tool (A).
Special tool
(A): 09912-38310
5) Remove connecting rod bearing caps (1).
6) Decarbonize top of cylinder bore before removing piston
from cylinder.
7) Push piston and connecting rod assembly out through the
top of cylinder bore.
Installation
1) Apply engine oil to pistons, rings, cylinder walls, connecting
rod bearings and crank pins.
NOTE:
Do not apply oil between connecting rod and bearing or
between bearing cap and bearing.