Suzuki Wagon R Manual page 3388

Select Cable
1. Selector lever assembly
2. Select cable
3. Select cable retainer
4. Cable bracket
5. Manual select lever
6. Clip
7. Select cable retainer bolt
8. Manual select lever pin
: Apply lithium grease 99000-25010 to all around pin (0.15 g)
9. Selector lever pin
: Apply lithium grease 99000-25010 to all around pin (0.15 g)
Tightening torque
Removal
1) Remove parking brake lever cover.
2) Remove console box.
3) Disconnect select cable from selector lever and then detach
from bracket.
4) Remove clip and disconnect select cable from manual select
lever.
5) Remove select cable retainer from dash panel.
Installation
Install select cable by reversing removal procedure.
The important steps in installation are as follows.
• Apply grease to pin and cable joint.
• Tighten bolts in upper figure to specified torque.
• Adjusting procedure is as follows.
AUTOMATIC TRANSAXLE (M13 ENGINE MODEL) 7B1-95