Suzuki Wagon R Manual page 3510

INSTALLATION
1) Drive in a new No.1 bush using special tools, and then apply
grease to bush inside.
Special tool
(A): 09930-30104
(B): 09923-46030
"A": Grease 99000-25010
2) Install release shaft with return spring.
3) Apply grease to No.2 bush (1) inside and press-fit it using the
same special tool as in removal.
"A": Grease 99000-25010
Special tool
(A): 09922-46010
4) Coat grease to shaft seal (2) lip and then install it till it is flush
with case surface. Use special tool for this installation and
face seal lip downward (inside).
"A": Grease 99000-25010
Special tool
(B): 09925-98221
5) Caulk seal at A using caulking tool and hammer.
6) Hook return spring (4).
7) Apply grease to release bearing (1) inside and release shaft
arm (2), then set release bearing.
"A": Grease 99000-25010
8) Apply small amount of grease to input shaft (3) spline (0.3 g)
(0.01 oz) and front end (0.15 g) (0.005 oz) as well.
"B": Grease 99000-25210
CLUTCH (G10/M13 ENGINE MODELS) 7C-11