Suzuki Wagon R Manual page 3771

6-4-90 ENGINE GENERAL INFORMATION AND DIAGNOSIS (Z10XEP AND Z12XEP ENGINES)
Test
T06 Check: Component
• Engine running
• Press YES key ON
• Scan Tool Data List Parameter
Port Deactivation Position Sensor
NOTE:
The data list parameter is displayed during the test.
Yes: E01
T07 Check: Mechanical Functionality
• Check mechanical functionality of the following components and all
attached parts:
Vacuum hose
Vacuum supply system
Actuating linkage lever
Yes: E02
Result Table
Result
E01 • Defective component:
ECM
NOTE:
If ECM is replaced, register password (PWD) and secret key code (SKC) to ECM referring to
"Procedure after ECM Replacement" in Section 8G3.
E02 • Defective component:
Twinport sensor
E03 • Repair the concerned mechanical component
E04 • Short circuit to voltage/interruption of circuit between:
ECM - Wiring harness connector (wiring harness side) terminal C36-10
&
Twinport sensor - Wiring harness connector (wiring harness side) terminal C22-2
or
• Defective component:
ECM
NOTE:
If ECM is replaced, register password (PWD) and secret key code (SKC) to ECM referring to
"Procedure after ECM Replacement" in Section 8G3.
E05 • Short to voltage/ground/interruption of circuit between:
ECM - Wiring harness connector (wiring harness side) terminal C36-44
&
Twinport sensor - Wiring harness connector (wiring harness side) terminal C22-1
or
• Defective component:
ECM
NOTE:
If ECM is replaced, register password (PWD) and secret key code (SKC) to ECM referring to
"Procedure after ECM Replacement" in Section 8G3.
Work Order Description
Cause Of Fault
Nominal Value
1.5 – 2.0 V
No: T07
Test OK?
No: E03