Suzuki Wagon R Manual page 3642

Compressor
Removal
Z10XEP and Z12XEP Engine Models
1) Run engine at idle speed with air conditioning ON for 10 min-
utes. After that, stop the engine.
2) Disconnect negative (–) cable at battery.
3) Recover refrigerant from refrigeration system by using
recovery and recycling equipment.
4) Remove front bumper referring to "Front Bumper and Rear
Bumper" in Section 9.
5) Disconnect horn connector, and remove horn (1).
6) Remove engine front cover (2).
7) Remove compressor drive belt referring to "Accessory Drive
Belt Removal and Installation" in Section 6B4.
8) Disconnect suction and discharge hoses from compressor.
NOTE:
Cap open fittings immediately to keep moisture out of
system.
9) Disconnect magnet clutch connector (3) and disengage lead
wire clamp.
10) Remove compressor with magnet clutch assembly (1) from
its mount by loosening mounting bolts (2).
11) Drain oil from compressor, and measure its amount.
Z13DT Engine Model
Refer to the same section of the Service Manual mentioned in the
"FOREWORD" of this service manual.
AIR CONDITIONING (OPTIONAL) 1B-23