Suzuki Wagon R Manual page 3944

[A]
[B]
ENGINE AND EMISSION CONTROL SYSTEM (Z10XEP AND Z12XEP ENGINES) 6E4-15
For HO2S-1
a) Remove HO2S-1 from exhaust manifold according to pro-
cedure described in "Exhaust Manifold Removal and Instal-
lation" in Section 6A4.
For HO2S-2
a) Hoist vehicle.
b) Disconnect connector of HO2S-2 and release its wire har-
ness from clamp.
c) Remove HO2S-2 (1) from exhaust pipe.
Installation
Reverse removal procedure noting the following.
• Tighten HO2S-1 and/or HO2S-2 (1) to specified torque.
Tightening torque
HO2S-1 and/or HO2S-2 (a): 40 N·m (4.0 kg-m, 29.5 lb-ft)
• Connect connector of HO2S-1 and/or HO2S-2 (1) and clamp
1,(a)
wire harness securely.
• After installing HO2S-1 and/or HO2S-2 (1), start engine and
check that no exhaust gas leakage exists.
[A]: HO2S–1
[B]: HO2S–2
1,(a)
Camshaft Position Sensor (CMP Sensor)
Removal and Installation
Removal
1) Disconnect negative cable at battery.
2) Remove intake pipe.
3) Disconnect connector from CMP sensor.
4) Remove CMP sensor from cylinder head.