Suzuki Wagon R Manual page 3855

6A4-28 ENGINE MECHANICAL (Z10XEP AND Z12XEP ENGINES)
Installation
1) Install clutch cover and clutch disc and flywheel referring to
"Clutch Cover, Clutch Disc and Flywheel Removal and Instal-
lation" in Section 7C5.
2) Connect transaxle to engine referring to "Transaxle Unite
Dismounting and Remounting" in Section 7A5.
3) Lift engine with transaxle into engine compartment, but do
not remove lifting device.
4) Tighten engine rear mounting bolt (1), engine left mounting
nuts (2) and engine right mounting bracket bolts (3) to speci-
fied torque.
Tightening torque
Engine rear mounting bolt
(a): 55 N·m (5.5 kg-m, 40.0 lb-ft)
Engine left mounting nut
(b): 55 N·m (5.5 kg-m, 40.0 lb-ft)
Engine right mounting bracket bolt
(c): 55 N·m (5.5 kg-m, 40.0 lb-ft)
5) Remove lifting device.
6) Install A/C compressor to its bracket. (if equipped)
7) Install coolant hose.
8) Install cover plate.
9) Install horn, and connect horn coupler.
10) Install front bumper referring to "Front Bumper and Rear
Bumper" in Section 9.
11) Connect right and left drive shaft joints to differential gear
referring to "Front Drive Shaft Assembly Removal and Instal-
lation" in Section 4A5.
12) Install exhaust pipe referring to "Exhaust Pipe Removal and
Installation" in Section 6K4.
13) Install lower coolant pipe and hoses.
Tightening torque
Lower coolant pipe bolt: 25 N·m (2.5 kg-m, 18.0 lb-ft)
14) Install accessory drive belt referring to "Accessory Drive Belt
Removal and Installation" in Section 6B4.
15) Install accessory drive cover.
16) Connect hoses, cables and electric wires disconnected in
removal procedure.
Tighten ground cable bolt for transaxle to specified torque.
Tightening torque
Ground cable bolt: 25 N·m (2.5 kg-m, 18.0 lb-ft)
17) Install EVAP canister.
18) Install air cleaner assembly referring to "Air Cleaner Assem-
bly Removal and Installation" in this section.
19) Check to ensure that all removed parts are back in place.
Reinstall any necessary parts which have not been rein-
stalled.