Suzuki Wagon R Manual page 3740

C-06: Pedal Position Sensor Circuit
Test Table
Test
T01 Check: Short to Voltage/Ground/Interruption of Voltage Supply
• Ignition OFF
• All consumers turned off
• Disconnect wiring harness connector from:
Accelerator pedal position sensor
• Ignition ON
• Measure voltage between the following terminals:
Accelerator pedal position sensor - Wiring harness connector (wir-
ing harness side) terminal G82-6
&
Ground
Yes: T02
T02 Check: Short to Voltage/Ground/Interruption of Voltage Supply
• Measure voltage between the following terminals:
Accelerator pedal position sensor - Wiring harness connector (wir-
ing harness side) terminal G82-5
&
Ground
Yes: T03
T03 Check: Short to Voltage/Interruption of Ground Circuit
• Measure voltage between the following terminals:
Accelerator pedal position sensor - Wiring harness connector (wir-
ing harness side) terminal G82-3
&
Accelerator pedal position sensor - Wiring harness connector (wir-
ing harness side) terminal G82-5
Yes: T04
T04 Check: Short to Voltage of Signal Circuit
• Scan Tool Data List Parameter
APP Sensor 1 Volt
Yes: T05
T05 Check: Short to Ground/Interruption of Signal Circuit
• Connect fused jumper wire to:
Accelerator pedal position sensor - Wiring harness connector (wir-
ing harness side) terminal G82-5
&
Accelerator pedal position sensor - Wiring harness connector (wir-
ing harness side) terminal G82-4
• Scan Tool Data List Parameter
APP Sensor 1 Volt
Yes: T06
ENGINE GENERAL INFORMATION AND DIAGNOSIS (Z10XEP AND Z12XEP ENGINES) 6-4-59
Work Order Description Nominal Value
4.8 – 5.2 V
No: T15
4.8 – 5.2 V
No: T11
4.8 – 5.2 V
No: E09
less than 0.3 V
No: E08
4.8 – 5.2 V
No: E07