Suzuki Wagon R Manual page 3363

7B1-70 AUTOMATIC TRANSAXLE (M13 ENGINE MODEL)
DTC P0962 Pressure Control Solenoid Control Circuit Low
Wiring Diagram
1. TCM
2. Pressure control solenoid valve
DTC Detecting Condition and Trouble Area
DTC DETECTING CONDITION
Pressure control solenoid valve output voltage is too low
comparing with TCM command value.
DTC Confirmation Procedure
1) Connect scan tool to DLC with ignition switch OFF, if available.
2) Clear DTC in TCM memory.
3) Start engine.
4) Keep engine running at idle speed for 30 seconds or more.
5) Stop vehicle and check DTC.
DTC Troubleshooting
Step
1 Was "Automatic Transaxle Diagnostic Flow Table"
performed?
12V
E13-4
E13-2
[A]
E13
4 2
3. A/T
[A]: Terminal arrangement of TCM connector (Viewed from harness side)
Action
1
2
BRN/YEL
LT GRN/RED
E12
TROUBLE AREA
• Pressure control solenoid valve circuit open or
shorted to ground.
• Malfunction of pressure control solenoid valve
• TCM
Yes
Go to Step 2.
3
No
Go to "Automatic Tran-
saxle Diagnostic Flow
Table" in this section.