Suzuki Wagon R Manual page 3857

6A4-30 ENGINE MECHANICAL (Z10XEP AND Z12XEP ENGINES)
Timing Chain Cover Removal and Installation
Removal
1) Remove engine assembly from engine compartment refer-
ring to "Engine Assembly Removal and Installation" in this
section.
2) Remove oil pan referring to "Oil Pan and Oil Pump Strainer
and Oil Baffle Plate Removal and Installation" in this section.
3) Disconnect hose (1) from coolant pump.
4) Remove engine harness assembly by unclipping wiring
trough (2) and disconnecting the following couplers.
• Oil pressure switch (3)
• ECT sensor (4)
• CMP sensor (5)
5) Remove cylinder head cover referring to "Cylinder Head
Cover Removal and Installation" in this section.
6) Remove engine right mounting bracket referring to "Engine
Mounting Components" in this section.
7) Remove accessory drive belt after marking installing direc-
tion.
8) Remove special tool from belt tensioner (1), then belt ten-
sioner.
Special tool
(A): 09919-58330
9) Remove generator from cylinder head referring to "Genera-
tor Removal and Installation" in Section 6H4.
10) Remove upper coolant pipe (1).
11) Remove coolant pump pulley.
1