Suzuki Wagon R Manual page 3723

6-4-42 ENGINE GENERAL INFORMATION AND DIAGNOSIS (Z10XEP AND Z12XEP ENGINES)
Test
T26 Check: Component
• Disconnect wiring harness connector from:
Immobilizer control module
• Insert new fuse into the socket of the fused jumper wire and then
check this fuse for proper operation.
• Disconnect each of the following components/control units from
the wiring harness consecutively and check the fuse of the fused
jumper wire for proper operation each time:
Information display
Combination meter
Yes: E13
Result Table
Result
E01 • Defective component:
ECM
NOTE:
If ECM is replaced, register password (PWD) and secret key code (SKC) to ECM referring to
"Procedure after ECM Replacement" in Section 8G3.
E02 • Circuit interruption between:
Data Link Connector - Wiring harness connector (wiring harness side) terminal G09-4
&
Ground
E03 • Circuit interruption between:
ECM - Wiring harness connector (wiring harness side) terminal G21-2
&
Immobilizer control module - Wiring harness connector (wiring harness side) terminal G17-7
E04 • Circuit interruption between:
Circuit fuse - Output contact
&
ECM - Wiring harness connector (wiring harness side) terminal G21-51
E05 • Circuit interruption between:
Ignition switch - Wiring harness connector (wiring harness side) terminal G24-2
&
Circuit fuse - Input contact
or
• Defective component:
Ignition switch
E06 • Circuit interruption between:
Main fuse - Output contact
&
Main fuse - Input contact
or
• Circuit interruption between:
Main fuse - Output contact
&
Ignition switch - Wiring harness connector (wiring harness side) terminal G24-5
Work Order Description
Cause Of Fault
Nominal Value
Test OK?
No: E24