Suzuki Wagon R Manual page 3262

MANUAL TRANSAXLE (M13 ENGINE MODEL) 7A2-15
Remounting
CAUTION:
Care should be taken not to scratch oil seal lip with drive
shaft while raising transaxle.
Do not hit drive shaft joint with hammer when installing it
into differential gear.
Reverse dismounting procedure for remounting noting the follow-
ing.
• Install transfer referring to "Transfer Dismounting and
Remounting" in Section 7D, if equipped.
• Refer to "Transaxle Unit Components" for fastener specified
torque.
• Push in drive shaft joints (right & left) fully so as to snap ring
of shaft engages with differential gear.
• Set each clamp for wiring securely.
• Install starting motor referring to "Starting Motor Dismounting
and Remounting" in Section 6G.
• After connecting clutch cable, be sure to adjust its play prop-
erly.
Refer to "Clutch Pedal Inspection" in Section 7C.
• Fill transaxle with oil as specified referring to "Manual Tran-
saxle Oil Change" in this section.
• Connect battery and check function of engine, clutch and
transaxle.