Suzuki Wagon R Manual page 3923

6B4-16 ENGINE COOLING (Z10XEP AND Z12XEP ENGINES)
Accessory Drive Belt Tensioner Assembly
Removal and Installation
CAUTION:
Do not disassemble drive belt tensioner assembly. Disas-
sembly will spoil its original function. If any malcondition
is found in drive belt tensioner assembly, replace it as
assembly.
Removal
1) Remove drive belt referring to "Accessory Drive Belt
Removal and Installation" in this section.
2) Remove tensioner as follows.
a) Tension accessory drive belt tensioner in arrow direction as
shown in figure.
b) Insert special tool.
Special tool
(A): 09919-58330
c) Remove accessory drive belt tensioner (1).
Installation
1) Install tensioner as follows.
a) Install tensioner (1).
Tightening torque
Tensioner bolt (M8)
(a): 20 N·m (2.0 kg-m, 14.5 lb-ft)
Tensioner bolt (M10)
(b): 55 N·m (5.5 kg-m, 40.0 lb-ft)
b) Tension accessory drive belt tensioner in arrow direction.
c) Remove special tool.
Special tool
(A): 09919-58330
Water Pump Removal and Installation
Removal
1) Disconnect negative cable at battery.
2) Drain coolant referring to "Cooling System Draining" in sec-
tion.
3) Remove thermostat referring to "Thermostat Removal and
Installation" in this section.