Suzuki Wagon R Manual page 3895

6A4-68 ENGINE MECHANICAL (Z10XEP AND Z12XEP ENGINES)
Removal
1) Remove engine assembly from engine compartment refer-
ring to "Engine Assembly Removal and Installation" in this
section.
2) Remove piston and connecting rod referring to "Pistons, Pis-
ton Rings, Connecting Rods and Cylinder Removal and
Installation" in this section.
3) Loosen lower crankcase bolts gradually in symmetrical order
starting from the outside inward.
4) Remove lower crankcase from cylinder block.
5) Remove crankshaft (1) and flywheel side crankshaft oil seal
from cylinder block.
6) Remove main bearings from cylinder block and lower crank-
case.
Mark main bearings using silver pencil or quick drying paint.
7) Remove CKP sensor ring (1) from crank shaft.
Installation
1) Clean sealing surfaces for cylinder block and lower crank-
case.
2) Install CKP sensor ring to crankshaft.
Tightening torque
CKP sensor ring bolt:
15 N·m (1.5 kg-m, 11.0 lb-ft)