Suzuki Wagon R Manual page 3989

7A5-12 MANUAL TRANSAXLE (Z12XEP ENGINE MODEL)
17) Remove engine rear mounting with bracket (1).
1
18) Remove transaxle to engine bolts. (lower side)
19) Pull transaxle out so as to disconnect cluster gear from
Remounting
Reverse dismounting procedure for remounting noting the follow-
ing.
clutch disc and then lower it.
• Refer to figure at the title of "Transaxle Unit Dismounting and
Remounting" for fastener specified torque.
• Tighten lower coolant pipe to specified torque.
Tightening torque
Lower coolant pipe bolt:
25 N·m (2.5 kg-m, 18.0 lb-ft)
• Set each clamp for wiring securely.
• After connecting clutch cable, be sure to adjust clutch cable
nut position referring to "Clutch Cable Adjustment" in Section
7C5.
• Install front drive shafts referring to "Front Drive Shaft
Assembly Removal and Installation" in Section 4A5.
• Fill transaxle with oil as specified referring to "Manual Tran-
saxle Oil Change" in this section.
• Connect battery and check function of engine, clutch and
transaxle.
• Refill coolant referring to "Cooling System Flush and Refill"
in Section 6B4.