Suzuki Wagon R Manual page 3663

4A5-4 FRONT DRIVE SHAFT (Z12XEP ENGINE MODEL)
Installation
CAUTION:
• Be careful not to damage oil seals and boots when
installing drive shafts.
• Do not hit boot with hammer. Inserting boot only by
hands is allowed.
• Make sure that differential side joint is inserted fully
and its snap ring is seated as it was.
Install drive shaft assembly by reversing removal procedure not-
ing the following points.
• Install wheel side joint to steering knuckle first, and then dif-
ferential side joint to transaxle.
• Tighten each bolt and nut to the specified torque referring to
"Front Drive Shaft Assembly Components" in this section.
• Fill transaxle with oil referring to "Manual Transaxle Oil
Change" in Section 7A5.
• Check toe setting and adjust referring to "Toe Setting" and
"Toe Adjustment" in Section 3A.
Front Drive Shaft Assembly Inspection
Inspection
• Check boots for breakage or deterioration.
• Check wheel side joint for rattle or smoothness.
• Check differential side joint for smoothness.
If any abnormality is found, replace.