Suzuki Wagon R Manual page 3885

6A4-58 ENGINE MECHANICAL (Z10XEP AND Z12XEP ENGINES)
Pistons, Piston Rings, Connecting Rods and Cylinder Components
1. Top ring 5. Connecting rod
2. 2nd ring 6. Connecting rod bearing
3. Oil ring 7. Connecting rod bearing cap
4. Piston 8. Connecting rod bearing cap bolt
Tighten 13 N·m (1.3 kg-m, 9.5 lb-ft), 60° and 15° by the
specified procedure.
Apply engine oil to sliding surface.
Pistons, Piston Rings, Connecting Rods and
Cylinder Removal and Installation
CAUTION:
• Connecting rod and connecting rod bearing cap must
be replaced as a set when either replacement becomes
necessary.
• Note original position in which all pistons, piston
rings, connecting rods and connecting rod bearing
caps were installed, and install them to original posi-
tion.
If each piston, piston ring, connecting rod and con-
necting rod bearing cap is not installed to original
position, engine will spoil its original performance.
• Mating surfaces of connecting rod and connecting rod
bearing cap form individual fit and must not be dam-
aged or exchanged.
• Do not lay on mating surfaces.