Suzuki Wagon R Manual page 3721

6-4-40 ENGINE GENERAL INFORMATION AND DIAGNOSIS (Z10XEP AND Z12XEP ENGINES)
Test
T14 Check: Component
• Remove fused jumper wire
• Disconnect wiring harness connector from:
Starting Motor - Wiring harness connector (wiring harness side)
terminal C06-1
• Connect fused jumper wire to:
Ignition switch - Wiring harness connector (wiring harness side)
terminal G24-3
&
Battery voltage
• Check the following component for proper operation:
Fuse of the fused jumper wire
Yes: E07
T15 Check: Component
• Connect fused jumper wire to:
Circuit fuse - Output contact
&
Battery voltage
• Check the following component for proper operation:
Fuse of the fused jumper wire
Yes: E01
T16 Check: Short to Ground of Voltage Supply Circuit
• Disconnect wiring harness connector from:
Ignition module
• Insert new fuse into the socket of the fused jumper wire and then
check this fuse for proper operation.
• Disconnect each of the following components/control units from
the wiring harness consecutively and check the fuse of the fused
jumper wire for proper operation each time:
Immobilizer control module
ABS control module
EPS control module
Yes: E13
T17 Check: Short to Ground of Voltage Supply Circuit
• Remove electrical component from socket:
Blower fan relay
• Insert new fuse into the socket of the fused jumper wire and then
check this fuse for proper operation.
• Disconnect each of the following components/control units from
the wiring harness consecutively and check the fuse of the fused
jumper wire for proper operation each time:
A/C compressor relay
A/C switch
Yes: E13
T18 Check: Short to Ground/Interruption of Voltage Supply Circuit
• Remove electrical component from socket:
Circuit fuse
• Check the following component for proper operation:
Circuit fuse
Yes: T19
Work Order Description Nominal Value
Test OK?
No: E08
Test OK?
No: T16
Test OK?
No: T17
Test OK?
No: E14
Test OK?
No: T25