Suzuki Wagon R Manual page 3747

6-4-66 ENGINE GENERAL INFORMATION AND DIAGNOSIS (Z10XEP AND Z12XEP ENGINES)
Result
E04 • Circuit interruption between:
ECM - Wiring harness connector (wiring harness side) terminal G21-5
&
Accelerator pedal position sensor - Wiring harness connector (wiring harness side) terminal
G82-2
or
• Defective component:
ECM
NOTE:
If ECM is replaced, register password (PWD) and secret key code (SKC) to ECM referring to
"Procedure after ECM Replacement" in Section 8G3.
E05 • If the nominal value is reached during one of the measurements, there is a short to voltage in
the circuit behind the component that has been disconnected immediately before that measure-
ment, or the corresponding component is defective.
E06 • Short circuit to voltage between:
ECM - Wiring harness connector (wiring harness side) terminal G21-5
&
Accelerator pedal position sensor - Wiring harness connector (wiring harness side) terminal
G82-2
&
Wiring harness connector terminals of all components (wiring harness side), which were discon-
nected from the wiring harness during this trouble shooting session
E07 • Short circuit to ground/interruption of circuit between:
ECM - Wiring harness connector (wiring harness side) terminal G21-54
&
Accelerator pedal position sensor - Wiring harness connector (wiring harness side) terminal
G82-4
or
• Defective component:
ECM
NOTE:
If ECM is replaced, register password (PWD) and secret key code (SKC) to ECM referring to
"Procedure after ECM Replacement" in Section 8G3.
E08 • Short circuit to voltage between:
ECM - Wiring harness connector (wiring harness side) terminal G21-54
&
Accelerator pedal position sensor - Wiring harness connector (wiring harness side) terminal
G82-4
or
• Defective component:
ECM
NOTE:
If ECM is replaced, register password (PWD) and secret key code (SKC) to ECM referring to
"Procedure after ECM Replacement" in Section 8G3.
Cause Of Fault