Suzuki Wagon R Manual page 4064

Diagnostic Trouble Code (DTC) Table
Immobilizer Control Module
DTC No.
B1000 Immobilizer Control Module internal failure
B3040 W-line communication failure
B3042 W-line circuit shorted to ground
B3043 W-line circuit shorted to battery
B3055 No transponder
B3056 No FIX CODE (FC) registered
B3057 No password (PWD) registered
B3059 No request from ECM
B3060 Incorrect transponder detected
B3061 Transponder communication fail
B3077 Read-only transponder detected
ECM
DTC No.
Display on
Scan Tool
SECRET KEY CODE (SKC) and password
P1610
(PWD) not registered
P1611 PWD not matched
P1612 No signal from Immobilizer Control Module
P1613 No signal from Immobilizer Control Module
Incorrect signal from Immobilizer Control
P1614
Module
NOTE:
• DTC B3040, B3042 and B3043 not be confirmed by scan tool unless W-line circuit is in good condi-
tion.
• DTC B3059 is detected when ignition switch is turned to ON (I) position within 5 seconds after igni-
tion switch turned to (I) or (●) position from (II) position.
IMMOBILIZER CONTROL SYSTEM (Z10XEP / Z12XEP ENGINE MODELS) 8G4-9
Detected Item
Detected Item
Detecting Condition
Immobilizer control module failure
Communication not finished correctly
W-line circuit voltage low
W-line circuit voltage high
Ignition key without transponder is used.
FC is not registered in Immobilizer control mod-
ule.
PWD is not registered in Immobilizer control
module.
ECM / Immobilizer control module line (SVS
lamp) is open or shorted.
Unregistered transponder is detected.
Incorrect signal or no response from transpon-
der
Transponder not for this system is detected.
Detecting Condition
SKC and PWD are not registered in ECM.
Stored PWD is incorrect.
Invalid signal from Immobilizer control module
Invalid signal from Immobilizer control module
Received response from transponder is incor-
rect.