Suzuki Wagon R Manual page 3894

Main Bearings, Crankshaft and Cylinder Block Components
1. Cylinder block
2. Crankshaft
: Apply engine oil to sliding surface.
3. Main bearing (with thrust bearing)
: Apply engine oil to sliding surface.
4. Flywheel side crankshaft oil seal
: Apply grease 99000-84E00 to oil seal lip.
5. Main bearing
: Apply engine oil to bearing inside surfaces.
ENGINE MECHANICAL (Z10XEP AND Z12XEP ENGINES) 6A4-67
6. Lower crankcase
7. Crankcase bolt (M8)
8. Crankcase bolt (M6)
9. CKP sensor ring
10. CKP sensor ring bolt
Main Bearings, Crankshaft and Cylinder
Block Removal and Installation
CAUTION:
Note original position in which each main bearing were
installed, and install them to original position.
If each main bearing is not installed to original position,
engine will spoil its original performance.
NOTE:
• All parts to be installed must be perfectly clean.
• Be sure to apply oil to crankshaft journals, main bear-
ings, main bearing (with thrust bearing), crankpins,
connecting rod bearings, pistons, piston rings and cyl-
inder bores.
11. Knock pin
Tighten 25 N·m (2.5 kg-m, 18.0 lb-ft) and 60°
by the specified procedure.
Tighten 10 N·m (1.0 kg-m, 7.5 lb-ft) and 60°
by the specified procedure.
15 N·m (1.5 kg-m, 11.0 lb-ft)
Do not reuse.