Data Management Center (Dmc); Overview; Operational Setup - GE LOGIQ 500 Advanced Reference Manual

Data Management Center (DMC)

Data Management Center (DMC)

Overview

.

Operational Setup

4–30
The LOGIQ 500 is capable of interfacing with a personal
computer (PC). This interface is used to send OB, GYN and
Vascular measurement and calculation data from the
LOGIQ 500 to the PC for display, processing and evaluation.
Additionally, the LOGIQ
personal computer (PC) and transfer it to the patient entry
menu.
NOTE: Data Management Center transfer function will not work
if the fetus number is greater than one with the Multigestation
Option. An error message appears:
"Multigestation data transfer is not supported"
DMC data transfer will function normally if the fetus number is
set to one.
The PC must be connected to Port A or B of the LOGIQ
by an RS-232C interface cable. "Computer" must be selected
for Port A or B on the Set Up/System Parameters page 5.
The Record 1 or Record 2 keys must be assigned to the
computer selection. The Record 1 and Record 2 presets are
found on Set Up/Systems Parameters page 5.
500 can accept patient data from a
LOGIQ 500 Advanced Reference Manual
2276614–100 Rev. 0
500