Re-Measurement - GE LOGIQ 500 Advanced Reference Manual

Advanced Cardiac Calculations

Re-measurement

Overview
Operation Method
.
4–38
Values obtained during Advanced Cardiac calculations or after
a calculation sequence has been completed can be
re-measured as long as those measurement results remain
displayed on the screen.
However, once the measured values are deleted from the
display by the CLEAR function or by scrolling off the top of the
measurement display area, re-measurement is not possible.
1. Complete the calculation or calculation sequence.
2. Measurements and resultant calculations will be
displayed in the designation area. Only those
measurements displayed are available for

re-measurement.

3. Press the Measurement key and the top of the Ellipse
rocker switch. The first measurement available to be
re-measured will be highlighted and the name is
duplicated at the bottom of the measurement display
area.
4. Use the Ellipse rocker switch to select the desired
value to re-measure.
Calculations and generic measurements are not
available to be re-measured and will be skipped in the
selection process.
NOTE: The re-measurement function is not available with the
Single Plane DISC and Bi-Plane DISC methods.
LOGIQ 500 Advanced Reference Manual
2276614–100 Rev. 0