GE LOGIQ 500 Advanced Reference Manual page 398

VCR Operating Instructions
Control Panel (cont'd)
.
.
8–22
Pause/Record
Used to begin a recording or pause operation.
In the scan image mode, pressing the Pause/Record key while
the VCR status icon is J starts the recording process.
When recording starts, the tape position, patient name, patient
ID, and date are recorded in the system as data to be
searched.
NOTE: Recording is not possible in a system other than the
system on which the tape was registered. (The Pause/Record
key does not light up for any system other than the system on
which the tape was registered.)
l
Pressing Pause/Record while the VCR is recording
pauses the recording.
Pressing Pause/Record when the VCR recording is
paused cancels the pause and resumes the recording.
NOTE: When a recording resumes, the tape position (index)
and patient information will be re-recorded in the system.
A single tape can record up to 39 indexes. It is recommended
that recording not be paused (or stopped) unnecessarily to
ensure effective utilization of a video tape.
Pressing Pause/Record while the VCR is operating pauses the
recording or playback.
Fast forward or rewind cannot be paused. (Fast-forward
search/Reverse search can be paused.)
Pressing Pause/Record when the VCR operation is paused
cancels the pause and resumes the VCR operation.
LOGIQ 500 Advanced Reference Manual
2276614–100 Rev. 0