GE LOGIQ 500 Advanced Reference Manual page 392

VCR Operating Instructions
Status Icon Display (cont'd)
Ext Video
Ö
Ö Ö Ö Ö
Tape insertion
Ö Ö Ö Ö Ö
Ö Ö Ö Ö Ö
Ö Ö Ö Ö Ö
.
Ö Ö Ö Ö Ö
8–16
The Ext Video key on the control panel will be partially lit.
If Ext Video is fully lit, the VCR video mode has been selected.
Press Ext Video to switch to the scan image mode.
If Ext Video is not lit, the video tape or VCR has not been
recognized. If a video tape has already been inserted, eject it
from the recorder and check the tape.
When using a new Tape, proceed to Registering a New Tape on
page 8–25 .
Insert a registered video tape into the VCR.
When a tape has been inserted, the VCR automatically rewinds
it up to the tape header so that the system can read and collate
the tape ID.
When rewinding is completed, the VCR will play it back to read
the tape ID. When the tape ID has been verified, the following
message appears at the bottom of the monitor.
System ID = #####, Tape ID = #####
After confirming the ID, the VCR automatically fast forwards the
tape to the position of the tape when it was first inserted.
NOTE: The time required for ID recognition and collation will
differ depending on the tape position upon insertion. It usually
takes at least one and half minutes. Do not press any key until
ID collation is completed.
LOGIQ 500 Advanced Reference Manual
2276614–100 Rev. 0