Safety - GE LOGIQ 500 Advanced Reference Manual

Safety

Operating Precautions
Applicable VCR
Installation
Power supply
LOGIQ 500 Advanced Reference Manual
2276614–100 Rev. 0
The Sony SVO-9500 MD is the only VCR recommended by GE
as a LOGIQ 500-connectable recording device.
The Sony SVO-9500 MD requires an interface/metal fitting kit
for installation on the CRT or console shelf. Commercially
available VCRs do not have a dedicated interface kit; therefore,
the LOGIQ 500 cannot support their remote control.
For more information, contact a GE Distributor, Affiliate or
Sales Representative.
The VCR must be properly installed in an approved
configuration using the dedicated VCR metal fittings to prevent
accidents such as the VCR falling over, and to prevent
electromagnetic interference. Metal-fittings must be installed
by a qualified service engineer.
To power the VCR, plug the power cable supplied with the VCR
into the power outlet for peripherals on the rear panel of the
LOGIQ 500. Do not use a power cable other than the power
cable supplied with the VCR. Do not plug in the power cable to
an outlet other than the power outlet for peripherals.
VCR Operating Instructions
8–5