GE LOGIQ 500 Advanced Reference Manual page 396

VCR Operating Instructions
Control Panel
Ext Video
Ö Ö Ö Ö Ö Ö Ö Ö
.
.
8–20
Ext Video
Allows the selection of the video (VCR playback image) mode
or scan image mode.
When the video mode is activated, the image displayed on the
monitor is switched from scan image to VCR image. The Ext
Video key is fully lit in the video mode.
Under the condition in which the video mode can be activated,
Ext Video is partially lit. If the video mode cannot be activated,
Ext Video is not lit.
To return to the scan image mode, press Exit Video again.
Pressing Exit Video when the VCR is recording stops the
recording.
Pressing Exit Video when the VCR is playing back a tape
stops the playback and selects the scan image mode.
NOTE: A video tape must be inserted into or ejected from the
recorder in the scan image mode.
The Cine function cannot be activated in the video mode.
Mic
This is a microphone-activating switch.
Press this key to simultaneously record anything spoken in the
vicinity of the console during a recording.
The microphone is located on the bottom right side of the
monitor.
NOTE: Doppler audio will be recorded even if the Mic key is
not activated.
LOGIQ 500 Advanced Reference Manual
2276614–100 Rev. 0