Auto Sequence Programming - GE LOGIQ 500 Advanced Reference Manual

SAVE Command
EXIT Command

Auto Sequence Programming

Hints
LOGIQ 500 Advanced Reference Manual
2276614–100 Rev. 0
The SAVE command will save the changes as the new
measurement sequence. Prior to saving, the following
message is displayed:
"Overwrite? Press 'ESC' to cancel. 'SET' to confirm."
Set saves the order changes. Esc causes nothing to happen.
If the rearrangement process was not completed, the message
displayed is:
"Complete the re–arrangement first."
If the exit command is selected before choosing, completing or
saving the order, the following message is displayed:
"Quit? Press 'ESC' to cancel. 'SET' to confirm."
Set exits from this screen. Esc causes nothing to happen.
If a new sequence programming was completed but not saved,
the message displayed is:
"Overwrite? Press 'ESC' to cancel. 'SET' to confirm."
Set saves the order changes and exits. Esc causes nothing to
happen.
If there is a series of measurements/calculations that are
routinely taken in a specific sequence, the auto sequence
feature of the system can be used to program these
measurements/calculations to automatically appear on the
display in the desired order. Refer to 14–84 for details on
programming an auto sequence.
Advanced Cardiac Calculations
4–65