Starting The Vcr - GE LOGIQ 500 Advanced Reference Manual

VCR Operating Instructions

Starting the VCR

VCR Start-Up
.
Checking Switches
POWER
Ö Ö Ö Ö Ö Ö Ö Ö Ö Ö
Ö Ö Ö Ö Ö Ö Ö Ö Ö Ö Ö Ö Ö Ö Ö Ö Ö Ö
Ö Ö Ö Ö Ö Ö Ö Ö
.
8–14
NOTE: If an alphanumeric character (such as y and n) needs
to be typed in during the VCR operation, the system must not
be in the Blue Shift mode.
If the Blue Shift key is lit up, press Blue Shift to cancel the
Blue Shift mode.
After all connections and setups are completed, the VCR can
be started and will be recognized. The operation flow from the
moment the LOGIQ
to the moment the VCR is set is summarized as follows:
Check that the LOGIQ
Off/Stand-by position and that the VCR Power switch is in the
ON (recessed) position.
At this time, the VCR power will still be off.
If the switch is lit, the VCR power cable has been connected to
an outlet other than the power outlet for peripherals on the rear
panel of the LOGIQ
NOTE: For safety reasons, always connect the VCR power
cable to the power outlet for peripherals on the rear panel of the
LOGIQ 500.
500 Power/Stand-by switch is turned on
500 Power/Stand-by switch is in the
500.
LOGIQ 500 Advanced Reference Manual
2276614–100 Rev. 0