GE LOGIQ 500 Advanced Reference Manual page 424

VCR Operating Instructions
A List of Problems and How To Troubleshoot Them (cont'd)
Problem
The VCR status icon doesn't ap-
pear.
Ö Ö Ö Ö Ö
Ö Ö Ö Ö Ö
Ö Ö Ö Ö Ö
?
Ö Ö Ö Ö Ö
ID collation is complete, but Ext
Video doesn't light up.
Ext Video
Ö Ö Ö Ö
Ö Ö Ö
Tape cannot be inserted into the
VCR.
Tape cannot be inserted into the
VCR.
Table 8–3. Operation Guide/Troubleshooting Problems (cont'd)
8–48
Possible Cause
System ID and tape ID are being
checked/collated.
A VCR-related key was pressed
during ID collation.
The VCR already has a tape.
Condensation has occurred in the
VCR.
If the system has a problem or suffers a failure, contact a
qualified service representative or a sales representative for
assistance.
Possible Corrective Action
When a tape is inserted into the
VCR, the system automatically re-
winds it to the tape header to con-
duct tape ID check/collation. After
checking/collating, the VCR auto-
matically fast forwards it to the ini-
tial tape position when the tape
was inserted. During this period,
the correct status icon doesn't ap-
pear on the screen. Wait for the
VCR to stop. When ID checking/
collation has been completed, the
message
System ID = #####,
Tape ID = #####
appears.
Eject the tape from the VCR, turn
the system power off, and re-start
the system.
Check the VCR for a tape.
If the VCR indicator AUTO OFF is
lit, condensation has occurred in
the VCR. Wait for the AUTO OFF
LED to go off.
LOGIQ 500 Advanced Reference Manual
2276614–100 Rev. 0