GE LOGIQ 500 Advanced Reference Manual page 295

Key to Tables (cont'd)
Parameter
Maximum Power
I
ob
Power-up Mode
Initialization Mode
Acoustic Output
Freeze
I
tt
I
ts
LOGIQ 500 Advanced Reference Manual
2276614–100 Rev. 0
Unit
mW Maximum temporal-average power output. For scanning modes,
this shall be the total power output of all the acoustic pulses.
2
mW/cm Output beam intensity.
In systems in which the user defines the power-up mode, this
shall be stated as either "user defined" or "not applicable" (n/a).
In systems in which the user defines the initialization mode, this
shall be stated as either "user defined" or "not applicable" (n/a).
If the system has acoustic output freeze, then this shall be stated
as "yes;" otherwise, it shall be stated as "no."
mm Transducer to transducer-output-face distance.
mm Typical value for the transducer stand-off distance. If the trans-
ducer assembly is normally used in contact with the patient, then
this shall be specified "contact" system.
Table 6–144. Key to IEC Table Value (cont'd)
IEC Acoustic Output Tables
Description
6–111