Recording/Playback/Image Search - GE LOGIQ 500 Advanced Reference Manual

VCR Operating Instructions

Recording/Playback/Image Search

.
Recording Procedure
Registering a new patient
Start recording
8–28
In order to record, playback and image search, the Starting the
VCR procedures must be completed. The monitor shows the
stop VCR status icon (J) and both the Ext Video and
Pause/Record keys on the control panel being partially lit.
NOTE: Recording is available only on the system if the tape
has been previously registered on that system.
When Ext Video is partially lit (the scan image mode), press the
New Patient key to enter new patient information.
The image search function, described later, enables tape
search/image search based on a patient name/patient ID and
scan date. Check the patient name/patient ID before starting
each patient examination.
Start the examination and scan the patient. Scanned images
are displayed on the monitor.
Press Pause/Record to begin recording.
When recording begins:
S
The Pause/Record key is fully lit.
S
The VCR status icon changes to recording (l).
S
The VCR counter is updated to indicate the recording time.
The patient information and tape position acquired at the
beginning of a recording will be stored on the system hard
drive.
LOGIQ 500 Advanced Reference Manual
2276614–100 Rev. 0