Distinguishing Each Fetus; Measurements/Calculations - GE LOGIQ 500 Advanced Reference Manual

Distinguishing Each Fetus

Measurements/Calculations

.
LOGIQ 500 Advanced Reference Manual
2276614–100 Rev. 0
For measurements/calculations and report page displays, the
fetuses are labeled A, B, C and D.
Each fetus is distinguished on the report pages by its letter and
total number of fetuses. For example, a report page could be
noted as FETUS:A/3. This is fetus A from a total of 3.
Following this fetal number designation, the user can use
twelve characters to describe the position and twelve
characters to describe placenta location of the fetus. This is
displayed as:
POS: ############ PLAC: ############
During measurements/calculations, all measurements are
performed on fetus A first. The user then switches to fetus B
and performs the same measurements, etc.
The user can switch between fetuses by pressing Blue Shift
and then N.
NOTE: A fetus change can be accomplished at anytime during
the exam. However, the Blue Shift, N function is NOT available
while a measurement cursor is active.
After changing to the next fetus, any measurements made will
be recorded and reported to the new designated fetus. Any
active measurement or calculation not completed will be
cancelled when the fetus number is changed.
OB–Multigestational
4–23