GE LOGIQ 500 Advanced Reference Manual page 418

VCR Operating Instructions
Saving/Reading the Data to be Searched
.
Saving the data to be searched
8–42
To conduct a search for a video tape recorded on another
LOGIQ 500, the index, patient information, and scan date
acquired when a recording is made are stored in the system
hard drive whenever recording begins. Also, an index marker is
recorded on the tape.
When an image search is initiated, the system conducts a
search of data in the system hard drive to determine the index
number of the relevant image, and transfers it to the VCR. The
VCR searches for the index marker on the tape in accordance
with the transferred index number. Thus, an image search
requires that the data being searched be stored in the hard disk
drive.
NOTE: To conduct an image search on a system other than
the system on which the relevant tape was registered, the data
to be searched needs to be copied onto the system in which an
image search is conducted.
In the LOGIQ 500 system, data in the system hard drive can
be saved on a video tape, then a system on which an image
search is to be conducted reads the data on the tape to copy
the data to be searched.
To save the data in the hard drive on a video tape, press Ctrl
and V simultaneously with Ext Video On. This causes the
following message to appear:
"Save patient information on VCR Tape? (y/n)".
To save the data on the tape, type in "Y". The system
automatically rewinds the tape up to the tape header and
records the data in the hard drive onto the tape in bar code.
When the data has been saved onto the tape, the VCR stop
(changing the status icon to J).
At this point, press Ext Video to place the system in the scan
image mode and then eject the tape from the recorder.
LOGIQ 500 Advanced Reference Manual
2276614–100 Rev. 0