GE LOGIQ 500 Advanced Reference Manual page 51

Setup
Realtime Calc Window
.
LOGIQ 500 Advanced Reference Manual
2276614–100 Rev. 0
The realtime measurement/calculation display is set with factory
defaults for each exam category. This display arrangement,
content and calculation method can be customized in Set Up/
Preset Program menu page 4 and Set Up/Custom Display
menu page 13.
See the Preset Program section of Chapter 14 (Customizing
Your System) of the Basic User Manual for details on setting:
S
Diastole Velocity for PI
S
Diastole Velocity for RI
S
Diastole Velocity for S/D (D/S)
S
Averaging Number for D Realtime Calc.
S
RI Calculation to bidirectional flow:
See the "D Realtime Calc" preset in Chapter 14 of the Basic
User Manual for details on customizing the appearance and
content of the realtime calculation display window.
This display appears in the upper left corner of the monitor. It
consists of 8 lines of information. If some values are not
detected, "????" will be displayed.
Example:
S
"MEAN" is selected as the trace method. TAMEAN and
TAMAX are traced automatically.
S
If TAMAX, TAMEAN and TAMOD (mode) are selected to be
displayed in the Realtime Doppler Calculation window,
"????" will be displayed as the value for TAMOD because it
was not traced.
NOTE: It is important to remember the trace method selected
in the soft menu or Set Up/Custom Display menu page 13.
Realtime Doppler Calculations
Vmin, Vd
Vmin, Vd
Vmin, Vd
1–5
Off, On
4–5