Patient Data Input - GE LOGIQ 500 Advanced Reference Manual

Data Management Center (DMC)

Patient Data Input

Preparation
Send Data
4–34
The PC (personal computer) can be used to read patient data
cards and transfer that data to the Patient Entry menu via the
DMC serial port connection.
Connect the PC and LOGIQ
cable and serial ports equivalent to the DMC cabling.
Assign "Computer" to the proper LOGIQ
Setup/System Parameter Menu page 5.
Display the New Patient Entry Menu on the LOGIQ
On the PC, read the hospital ID card with patient data and
transfer that data to the LOGIQ
displaying the following message on the LOGIQ
"Communicating with Computer now."
When the reception is complete with no errors, the the following
message on the LOGIQ
"Communication was Completed."
The patient data received is then displayed on the Patient Entry
Menu.
500 using an isolated RS232C
500 serial port in the
500. The transfer starts by
500 monitor:
LOGIQ 500 Advanced Reference Manual
2276614–100 Rev. 0
500.
500 monitor: