GE LOGIQ 500 Advanced Reference Manual page 403

New Tape Registration Complete
.
LOGIQ 500 Advanced Reference Manual
2276614–100 Rev. 0
Upon completing a new registration, the screen will display the
VCR status icon (J) and VCR counter.
NOTE: The tape header contains the system ID and tape ID
registration number recorded. Thus, no data is recorded on the
tape header.
When all the steps up to this point have been successfully
completed, the monitor and control panel status is as follows:
1. Ext Video on the control panel is partially lit.
2. Pause/Record on the control panel is partially lit.
3. The monitor shows the stop VCR status icon (J) and
VCR counter on the bottom left corner of the screen.
If these conditions have not yet been established, conduct
a check following the procedure in Registering a New Tape
on page 8–25 .
VCR Operating Instructions
8–27