GE LOGIQ 500 Advanced Reference Manual page 405

Start recording (cont'd)
.
Recording audio
Recording Complete
LOGIQ 500 Advanced Reference Manual
2276614–100 Rev. 0
If a paused recording restarts, the patient information and
tape position will also be stored in the system hard drive.
Therefore, each time the tape is paused/restarted or
stopped/restarted, the index heading markers are
generated with the current patient information.
Tape searches and image searches are performed based
on this information.
NOTE: A single video tape allows up to 39 index head search
markers to be recorded. More than 39 index markers can be
recorded, but the image search function can handle only up to
39 index markers.
Doppler audio can be recorded in stereo or monaural, while
doing Pulsed or Color Doppler studies. The stereo/monaural
selection is found in the Set Up/Preset program menu
page two.
If there is a need to add audio to the video tape while recording,
press the Mic key. (Blue Shift key must be enabled.)
Anything spoken in the vicinity of the console will be recorded.
The microphone is located on the bottom right side of the
monitor.
Press the Stop/Play key to complete recording
press the Pause/Record key to pause recording.
When recording is stopped, the VCR status icon changes to
stop (J). For pause, the status icon changes to paused
recording ( ).
In both cases, press Pause/Record to restart recording.
VCR Operating Instructions
OR
8–29