GE LOGIQ 500 Advanced Reference Manual page 422

VCR Operating Instructions
Operation Guide/Error Messages (cont'd)
No. Message
(13) Recording is not avail-
able
(14) Re–attempt to read
Tape ID? (y/n)
(15) Save patient informa-
tion on VCR Tape?
(y/n)
(16) Save patient informa-
tion on System? (y/n)
(17) Searching
(18) Search was completed.
(19) System ID = #####,
Tape ID = #####
(20) System ID = #####,
New Tape ID = #####
(21) This function is not
available.
8–46
Possible Cause
Tape is not registered to the sys-
tem and all attempts to check
have been completed
The tape ID cannot be read.
The operator pressed Ctrl and V
to save patient information on the
VCR tape.
The operator pressed Control and
S to save patient information on
the hard drive.
The VCR is searching the tape.
Wait for the search to be com-
pleted.
The VCR search is completed.
The tape was mounted.
A new tape was registered.
The function selected is not avail-
able for some reason (e.g., a
function disabling another func-
tion from being activated simulta-
neously has been initiated).
Table 8–2. Operation Guide/Error Messages (cont'd)
Possible Corrective Action
Use new tape. Find proper system
tape.
y) Type "y" to re-attempt reading
the tape ID.
n) Type "n" to cancel reading the
tape ID.
y) Type "y" to save information on
the tape.
n) Type "n" to cancel the save.
Refer to Saving/Reading the Data to
be Searched on 8–42 .
y) Type "y" to save information on
the hard drive.
n) Type "n" to cancel the save.
Refer to Saving/Reading the Data to
be Searched on 8–42 .
NOTE: Enter the tape ID on the
label to be attached to the tape.
LOGIQ 500 Advanced Reference Manual
2276614–100 Rev. 0