GE LOGIQ 500 Advanced Reference Manual page 419

Reading the data to be searched
.
LOGIQ 500 Advanced Reference Manual
2276614–100 Rev. 0
To store the data on a video tape in the system, press Ctrl and
S simultaneously with Ext Video On. This causes the following
message to appear:
"Save patient information to System? (y/n)".
To cancel this function, press "N"
To read the data into the system, press "Y". The system
automatically rewinds the tape up to the tape header, reads the
information on the tape and records it on the system hard drive.
When saving on the hard drive is complete, the VCR stops
(changing the status icon to J).
At this point, press Ctrl and I simultaneously to initiate an
image search or Play to begin playback.
NOTE: Recording is available only on the system on which the
relevant tape was registered.
The data to be searched on a video tape cannot be written
back into the system on which the tape was registered.
The original data on the system hard drive cannot be rewritten
by rewriting the information (copied) on the tape.
If a read fails or if an attempt is made to read the information
from a video tape on which no data to be searched has been
saved, the VCR plays for about 2 minutes, then rewind the tape
to its initial point before stopping.
VCR Operating Instructions
8–43