GE LOGIQ 500 Advanced Reference Manual page 145

Report Page Commands
List Type Reports
Hints
Select Reports (S–RP)
LOGIQ 500 Advanced Reference Manual
2276614–100 Rev. 0
Four commands at the bottom of the report page allow the user
to:
List Change the report format to the LIST type.
Edit Allows for deleting measurement data on
the report page
S–RP Used to select the titles and order of report
page printing.
Auto–P Automatically prints out all reports,
selected by the S–RP function, in
sequential order.
Use the Trackball to highlight the desired command and press
Set.
The List type report displays only those measurements or
calculations actually performed. The section order of the list is
the same that was programmed by the S–RP command. The
item order is the same as the standard report.
All commands are the same as the standard report. The
difference is the Return command. Selecting Return changes
the display to the standard format.
When the amount of section information will not fit on one page,
a new page is generated so that all will fit on the same page.
The customization of the cardiac calculation reporting is
accomplished with this function.
Select S–RP from any standard report display. The screen for
selecting the report order is displayed as shown in Figure 4–83.
Advanced Cardiac Calculations
4–99