GE LOGIQ 500 Advanced Reference Manual page 147

Operation and Messages
.
LOGIQ 500 Advanced Reference Manual
2276614–100 Rev. 0
ORDER
The ORDER command is used to erase all previous
designations and commence the order selection process.
Select the ORDER command from the bottom menu. The
message displayed is:
"Reset? Press 'ESC' to cancel. 'SET' to confirm"
Set erases the old order and starts the order selection process.
Esc causes nothing to happen.
To designate a new order, use the Trackball to move the cursor
to the desired selection.
Press Set. The order number is placed to the left of the
measurement group name. The highlighted cursor stays in it's
position until it is moved by the Trackball to the next selection.
Continue this process until the desired selections have been
made in the preferred order.
NOTE: If Apical 4 Chamber–Diastole is selected, the same
order number will be assigned to Apical 4 Chamber–Systole
and vice-versa.
Measurement groups not selected will not be printed.
RESET
The RESET command resets the displayed combination to the
factory defaults. Prior to resetting, the following message is
displayed:
"Reset? Press 'ESC' to cancel. 'SET' to confirm"
Set resets the order to factory defaults. Esc causes nothing to
happen.
Advanced Cardiac Calculations
4–101