GE LOGIQ 500 Advanced Reference Manual page 387

Part Names and Functions of the VCR Rear Panel (cont'd)
Figure 8–4. VCR Rear Panel (RS–232 Terminal & Dip Switch)
.
LOGIQ 500 Advanced Reference Manual
2276614–100 Rev. 0
7. AC IN (AC power input) terminal. Connect this power
inlet to a power outlet for peripherals on the rear panel
of the LOGIQ
VCR.
8. Ground terminal (Disabled).
9. INDICATE (indicator) terminal (Disabled).
(11)
Ñ Ñ Ñ Ñ Ñ Ñ Ñ Ñ Ñ Ñ
(10)
10. RS–232C (remote control) terminal. Connect this
terminal to the VCR/Color Printer Port A or B on the
LOGIQ 500 rear panel. The proper port must be
selected in the Set Up/System Parameters page 5
menu.
11. DIP switch (Settings fixed). When the VCR is
connected to the LOGIQ
the settings of the DIP switch.
Settings:
SW1: OFF (down)
SW2: OFF (down)
SW3: OFF (down)
SW4: OFF (down)
SW5: ON (up)
SW6: OFF (down)
NOTE: If the VCR is disconnected from the LOGIQ 500 , set
SW4 to ON (up).
VCR Operating Instructions
500 using the cable supplied with the
500 for use, do not change
Remote/local switch
8–11