Using Running Output Signal - YASKAWA SGM-A3 User Manual

APPLICATIONS OF Σ-SERIES PRODUCTS

3.7.5 Using Running Output Signal

Note
3

3.7.5 Using Running Output Signal

136
When output signals CLT+ and CLT- are used as the speed coincide output, set the following
memory switch (Cn-01 bit4) to 1.
CLT+, CLT- Output Signals
Cn-01 Bit 4
Selection
Sets the output conditions for output signals CLT+ (1CN-25) and CLT- (1CN-26).
Setting
Uses CLT+, CLT- output signals as a torque limit
0 output signal.
Refer to 3.1.3 for details.
Uses CLT+, CLT- output signals as a speed
1
coincide output signal.
Bit 4 of memory switch Cn-01
Torque
CLT+
limit
CLT-
detection
(1CN-25)
Speed
(1CN-26)
coincide
1) This section describes how to wire and use contact output signals TGON+, TGON- as a
running output signal. This signal indicates that a servomotor is currently running.
Photocoupler Output
Per output:
Maximum operation
voltage: 30 VDC
Maximum output
current: 50 mADC
Output → TGON+ 1CN-27
Output → TGON- 1CN-28
This output signal indicates that the motor is cur-
rently running.
It is used as an external interlock.
Factory
Setting: 0
Meaning
When CLT+, CLT- output
signals are changed, the
following bit data are also
changed:
• Status indication mode bit
data
• Monitor mode Un-05 bit 4
Servopack
1CN-27 TGON+
1CN-28 TGON-
Running Output (Brake Interlock
Output) Output)
For Speed/Torque Control
and Position Control
I/O power
supply
For Speed/Torque
Control and Control and
Position Control
Motor
speed
TGON+
(1CN-27)